FL301 Series Low Cost Digital Dn150 Agricultural Application Water Flow Sensor Price
Applications in beverage, chemical, pharmaceutical, petroleum, wastewater, water, mining, mineral processing, power, pulp and paper. And the chemical industry. Magnetic flowmeters are used in water treatment plants to measure treated and untreated sewage, process water, water, and chemicals. Mining and mineral processing industry applications include process water and process slurry flows and dense media flows.
Speifications
| |
| Converter | | Compact Type | IP65 | | Remote Type | IP65(IP68 optional) | | Measurement sensor | | Nominal Diameter | DN15-DN1000 | | Pressure rating
(High pressure can be customized) | DN6 - DN80, PN<4.0MPa | | | DN100 - DN150, PN<1.6MPa | | | DN200 – DN1000, PN<1.0MPa | | | DN1200 – DN2000, PN<0.6MPa | | Lining Material | Chloroprene rubber (CR),
Polytetrafluoroethylene (PTFE/F4),
Fluorinated ethylene propylene (FEP/F46),
Teflon(PFA) | | Electrode Material | 316L Stainless Steel, Hastelloy C, Hastelloy B, Ti, Ta, Pt | | IP Rate | IP68 | IP65 | | Medium temperature | -25 – 180℃ | -10 – 80℃ | | Serial communications | RS-485 | | | Output | Current (4-20 mA) , pulse , frequency , state switch | | Max measuring error | Measurement value ±0.5%(Flow speed > 1m/s)；
Measurement value ±0.5% ±2mm/s(Flow speed <1m/s) | | Repetitiveness | 0.15% | | Power supply | 100-240VAC,50/60Hz, 22VDC—26VDC | | Power consumption | Max 15VA | | Signal cable | Apply only to remote type | | Shielded cable | Signal section,wire: 0.5mm2 Cu /AWG20 | |
Main features
1. No moving assembly, no abrasion
2. Turn down ratio: 1:100
3. No flow lifting device
4. Applicable to various electronic conductive liquids
5. Not influenced by temperature, viscosity, pressure and density
6. Corrosion protection and self-diagnosis
7.Measure both to and reverse flow
8. Super large display, easy to operate
9. Long-term EEPROM, save data when power off
10. Support MODBUS/HART communication protocol
Installation Sketch
The sensor must not be installed at the inlet of the pump, but at the outlet of the pump.
There must be a straight pipe section with a lengthof at least 10*D (D is the inner diameter of theflowmeter) in front of the flowmeter, and a straight pipe section with a length of 5*D at the rear.
